#Tongue and groove router bits 1 4 pdf

I check the companies website to see if it was available as a pdf but it wasn't. This item also came without any documentation(not even a simple picture showing the dimensions), so later in time when you pull this off the shelf and among other bits, it would be near impossible to know this sets specifications unless you want to break out your dial calipers, or mark the box yourself, or make your own documentation. And as a result of it's inability to cut anything thicker than 3/4, it is impossible to offset the tongue and grove in any way at all unless you want the extra step of removing the sliver of wood left unremoved. So unless you are going to put typically sold 1inch stock (which could be anything over 3/4) through a planner than you are left with slivers of wood on either side (outsides) of the bit. And the tongue bit is literally sized for 3/4 in thick stock. Saws View All Router Bits Router Bit Sets Laminate Bits Straight Bits Stile. The result is a sloppy loose fit that, for me, is unacceptable when making cabinet doors and drawer faces. A 4 dust port is integrated into the steel cabinet-type stand for maximum. However, I found the groove to be larger than the actual thickness of plywood. I wanted to like this set as it would have been really handy to make groves sized for the actual thickness of plywood. These bits offered a reasonable cut, based on the very minimal cuts I made (less than 10 total inches). For best results, use with solid wood only. Even though some smaller tongue and groove bits can be utilized in a hand-held router the stability of a table will help keep the joint perfectly square.

Tongue and groove bits can take quite a big bite out of the wood, so using these bits in a router table is strongly recommended. This joint also provides a lot of gluing surface as well as aligning ease. Tongue and groove router bits will cut the 2 mating profiles for this easy to make woodworking joint with ease and with a simple setup. A tongue and groove joint is the ideal way to create flat, even joints for flooring, wainscoting, panels and tabletops. plywood to create shaker cabinet door with a plywood center panel. These router bits are designed specifically for use with 1/4 in. plywood is thinner than the stated thickness because of the dressing of the board. CMT's Customer Service # is 1-888-CMT-BITS.This unique tongue and groove Router bit set cuts a slot 5.2 mm thick which is perfect for making tongue and groove doors with a 1/4 in. In no event shall CMT's liability to buyer under any theory of liability exceed the purchase price of the product alleged to be defective.

The remedy provided in paragraph 1 is buyer's exclusive remedy for all claims and causes of action based upon or arising out of any allegation of product defect. Rockler Tongue and Groove Router Bit - 1/4' H x 1/4' Shank x 3/8 Depth of Cut Convertible arbor can be configured to cut both the tongue and groove for 3/4' stock.

CMT expressly disclaims all other statements or representations of product quality or performance made by sales representatives or in literature or documents given to buyer.

THE FOREGOING LIMITED WARRANTY IS GIVEN IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

Warranty excludes dull, misused, damaged, or re-sharpened tools.

If, for any reason, you are not satisfied with the performance of your CMT tools, and the tools were used only for their recommended application and in accordance with CMT's recommendations, you may return them to CMT for replacement. For California consumers: more information about our privacy practices.more information about our privacy practices. CMT carbide and carbide tipped router bits and saw blades are designed, engineered and manufactured to uncompromising standards for optimum performance and service life. For any difficulty using this site with a screen reader or because of a disability, please contact us at 1-80 or.